|
|
|
|
|
| |
| Hot Pouring Compound Type SP |  |
| on bitumen basis |
| according to VDE-specification |
| Technical Data |
| needle penetration (25°C) |
70 - 100 (x 0,1 mm) |
DIN EN 1426 |
| softening point ring and ball |
45 - 50°C |
DIN EN 1427 |
| break point accd. Fraaß |
max. - 10°C |
DIN EN 12 593 |
| paraffines |
max. 2 % |
DIN EN 12 606-1 |
| shrinkage |
ca. 6 - 8 % |
VDE 0291 |
| density (20°C) |
1,00 - 1,10 g/cm³ |
DIN EN ISO 3838 |
| flash point |
> 230°C |
DIN EN 22 592 |
| processing temperature |
max. 120°C |
|
Properties
Hot pouring compound with increased adhesive strength
and plasticity. The compound SP consists to 100 % of
bitumen and has a good adhesion on metals and cable
insulation materials.
Application
The hot pouring compound SP is used for filling of power
cable joint boxes to protect them from short-circuit,
corrosion, penetrating humidity and contamination.
Processing
1) Remove the cover of the bucket and check for humidity.
In case of humidity it must be removed before melting the
compound. Otherwise the danger of burns exists by
splashes of hot compound.
2) Warm up the compound to max. 120°C.
Avoid overheating by regular stirring
3) Fill the compound into the joint box. Pay attention to
the protection of hands and eyes.
4) The mould in which the compound is filled has to be dry
and clean.
|
5) After cooling under 50°C (compound solidifies) the
contraction of approx. 6 - 8 % should be refilled.
6) The caution rules for handling of heat sources and hot
liquids have to be considered.
Storage
The compound has an unlimited shelf life when stored in
dry conditions. Rusty buckets should not be used to heat
the compound therein. Refrain from using heavy rusty
buckets.
Packaging
- Standard packing 10 kg metal buckets with handle
- On special request also tins with 5 kg content
Delivery
On EURO-pallets or on one-way pallets
|
|
|
 |
|
