|
|
|
|
|
| |
| Hot Pouring Compound Type FH |  |
| on natural resin/paraffin basis |
| according to VDE-specification |
| Technical Data |
| drop point accd. Ubbelohde |
60 - 70°C |
DIN 51 801 / Blatt 2 |
| cone-penetration |
10 - 20 (x 0,1 mm) |
DIN 51 580 |
| shrinkage |
ca. 7 - 8 % |
VDE 0291 |
| density (20°C) |
1,00 - 1,05 g/cm³ |
DIN EN ISO 3838 |
| flash point |
> 180°C |
DIN EN 22 592 |
| processing temperature |
max. 135°C |
|
Properties
Bright hot pouring compound with an lower softening point
than bituminous hot pouring compounds. The compound
FH consists of natural resin and paraffins and has very
good adhesion properties on metals and cable insulation
materials.
Application
The hot pouring compound FH is used for filling of the
inner space of accessories (end sleeves, joints, coil boxes
etc.) for telecommunication cables to protect them from
corrosion, penetrating humidity and contamination.
Processing
1) Remove the cover of the bucket and check for humidity.
In case of humidity it must be removed before melting the
compound. Otherwise the danger of burns exists by
splashes of hot compound.
2) Warm up the compound to max. 135°C.
Avoid overheating by regular stirring
3) Fill the compound into the joint box. Pay attention to the
protection of hands and eyes.
4) The mould in which the compound is filled has to be dry
and clean.
|
5) After cooling under 50°C (compound solidifies) the
contraction of approx. 6 - 8 % should be refilled.
6) The caution rules for handling of heat sources and hot
liquids have to be considered.
Storage
The compound has an unlimited shelf life when stored in
dry conditions. Rusty buckets should not be used to heat
the compound therein. Refrain from using heavy rusty
buckets.
Packaging
- Standard packing 10 kg metal buckets with handle
- On special request also tins with 2 kg and 5 kg content
Delivery
On EURO-pallets or on one-way pallets
|
|
|
 |
|
